Need help?Do you have a question about the SITRONICS INTRACOM omniBAS and is the answer not in the manual?
Shows main changes related to the previous edition of the OmniBAS™ IDU Installation.
Explains the reasons for document changes effected in relation to the previous document edition.
Provides information concerning the installation and cabling of OmniBAS™ Indoor Units (IDUs).
Introduces the OmniBAS™ family of Intracom Telecom IP MW PtP portfolio.
Details safety precautions for handling and installing the OmniBAS equipment.
Details the requirements that must be met before commencing the installation process.
Provides a general overview of the cabling procedures for the system.
Details the mechanical installation procedures for the OmniBAS-2W unit.
Details the mechanical installation procedures for the OmniBAS-4W unit.
Details the mechanical installation procedures for the OmniBAS-8W unit.
Details the mechanical installation procedures for the OmniBAS-4P unit.
Covers the preparation and installation of power supply cables for the system.
Details the installation and connection of IF (Intermediate Frequency) tails.
Explains the procedures for terminating E1 interfaces.
Details the cable characteristics for Gigabit Ethernet interfaces.
Details the cable characteristics for Fast Ethernet interfaces.
Details the cable characteristics for STM-1 interfaces.
General| Category | Network Hardware |
|---|---|
| Max Data Rate | 300 Mbps |
| Interface | Ethernet (RJ-45) |
| Antenna | Internal |
| Security | WPA, WPA2, WEP |
To Next Page