HAVING TROUBLE? CALL 310.982.2877 OR EMAIL THETEAM@SIXTHREEZERO.COM
These final adjustments apply to all mechanical disc
brakes. The end goal is a caliper that is parallel to the
rotor, with even gaps on each side and an adequate
lever feel. Even though setting the pads against the rotor
should theoretically have aligned the caliper correctly, it
is common for further adjustments to be required.
Pull and release the brake lever a few times to check the
clearance at the grip. Check that the lever travel feels
adequate to slow and stop the bike. Typically, the pads
should feel like they are contacting the rotor at a
minimum of one-half the lever travel.
Make adjustments as necessary using the pad adjusters,
moving the pads in and out evenly on both sides.
03
FINAL ADJUSTMENTS
To Next Page
Loading...
