WATCH ASSEMBLY VIDEOS ON OUR YOUTUBE CHANNEL, HTTPS://SIXTHREEZERO.COM/PAGES/ASSEMBLY
The lever at a 90º angle, should be tight enough to feel resistance when you
close the lever. Make sure the front wheel is securely tightened and properly
aligned so there are no issues when you assemble the brakes.
NOTE
09
Lift the lever up towards the fork. If the lever does not
lock in place smoothly, loosen QR5 slightly and try again.
It will take a small amount of strength, but that is normal.
QR5
----
10
Once the front wheel is secured, lower the kickstand and
locate the front fender.
To Next Page
Loading...
