Xpert Alert
®
RF Alarm
Operation Guide
Mount and wire the alarm according to the installation instructions.
***Maximum distance between modules should be 200ft.
Press pairing button for 1 second on the panel module to enter setup mode for fast signal
strength updates.
Reposition the indoor module until 1 or more signal LEDs are illuminated green.
Verify the alarm is functioning by triggering an alarm condition on the outdoor panel and verify the
indoor Xpert Alert® alarm is alarming. Alarm LED on Xpert Alert® RF and Xpert Alert® alarms
will illuminate amber in color when alarming and the audible alarm will sound. For Xpert Alert® WiFi
alarm units, verify a text or email noti cation of alarm was received.
Verify at least 1 or more signal LEDs are illuminated green monthly , and repeat step 3 as you
are able.
Alarm LED
Pairing Button
Step 1: Installation
Step 2: Signal Strength Check
Step 3: Test Alarm
Monthly Testing
Signal Strength
To Next Page
Need help?
General
