To Next PageTo Next Page
Need help?Do you have a question about the SK Pang Electronics RSP-PICAN FD and is the answer not in the manual?
Lists the key features of the PiCAN FD board, including CAN FD modes, compatibility, and hardware specifications.
Explains how to configure the DB9 connector for different pinouts, depending on the type of CAN cable used.
Details the solder bridge configuration required for using an OBDII cable with the DB9 connector.
Describes the solder bridge configuration needed for connecting a standard CAN cable via the DB9 connector.
Explains how to make CAN connections using the 4-way screw terminal interface on the board.
Guides on how to use the onboard 120Ω terminator by inserting a jumper on a header pin.
Mentions the presence of a red LED on the board, connected to GPIO22.
Discusses optional items like JP5 for serial LCD and a switch mode power supply module.
Provides the command to install the `can-utils` package for CAN interface management.
Details commands to activate the CAN interface for CAN 2.0B and CAN FD modes.
General| Category | Computer Hardware |
|---|---|
| Manufacturer | SK Pang Electronics |
| Model | RSP-PICAN FD |
| Device Type | CAN Bus Interface |
| Interface | SPI |
| CAN Controller | MCP2517FD |
| CAN FD Support | Yes |
| Bitrate | Up to 8 Mbps |
| Connector | DB9 |
| LED Indicator | Yes |
| Compatibility | Raspberry Pi |
| Operating Voltage | 5V |
| Operating Temperature | -40°C to +85°C |
| Termination | 120 Ohm resistor, enabled/disabled via solder bridge |
| Dimensions | 65mm x 56.5mm |
