If the procedure is correct, the following words will appear on the screen:
RESET PROCEDURE COMPLETED
All your personal and team PINs and your PUK have been deleted.
Now you have to insert the new values for the next PINs and PUK
Your personal PIN 1
Your personal PIN 2
Your personal Team PIN 1
Your personal Team PIN 2
‘’’’’’’’’’’’’’’’’’’’’’’’’’’’’’’’’’
NEW CODES PROCEDURE INITIATED
Please insert the 4 digits for your personal PIN 1
Now you have to insert the first four digits from the SecureKey A1 KeyPad, as example “1234”.
Automatically will appear:
1234
Insertion of personal PIN 1 completed
1234
Please insert the next 4 digits for personal PIN 2
Continue with the same procedure up to the end of the setup for all the PINs and the PUK.
When the procedure will be complete this message will appear.
Your device is now configured, please disconnect the USB cable and reconnect it.
Now you must disconnect and connect the device again to complete the procedure.
Remember that all the PINs and the PUK are now saved in the device memory. You can repeat
this procedure if you need to change the PINs or the PUK. Remember that a new PUK does not
change the password generation results. Conversely, new PINs change all our passwords.
SecureKey is a patent pending SMART DEVICES S.R.L. product. www.securekey.it
SMART DEVICES S.R.L. - Via del Cristo 9/a - Bassano del Grappa (VI) - VAT IT04323160244 - info@securekey.it - Capitale sociale 10.000,00 euro i.v.
To Next Page
Loading...