pressure on the membranes to produce RO water. The system should yield 40-
50% recovery which is appropriate for this system. Actual water production will
depend on the feed water flow and pressure, temperature, and pre-filter
condition.
10. The system should not be operated using a self-closing hose handle or spray
nozzle. If the flow of RO water is stopped, the system is built with a safety blow-off
valve that will divert RO water to the waste stream. It is okay to use a spray nozzle
that does not stop the flow of RO water.
REMINDER – The PRO Series is not a high pressure washer.
When you are finished using the system,
11. TURN off the system with the switch on the pump motor.
12. FLUSH the system for 2 minutes.
13. TURN off the water source.
14. UNPLUG the power cord.
15. DISCONNECT all three hoses.
16. PLACE the system in the vertical position as shown below.
17. ALLOW excess water to drain from the system for a moment.
To Next Page
Loading...