SK PRO Series User Manual (English)

To Next Page

PRO SERIES

Portable Reverse Osmosis

OPERATORS MANUAL

WARNINGS

1. DO NOT stop the flow of waste water. Reverse Osmosis systems create waste

water in the process of making RO water.

2. DO NOT let the pump run dry. Line pressure water must be supplied to the

system before and during operation.

OPERATING INSTRUCTIONS

1. The system may be operated in the horizontal position as shown above, or in the

vertical position. It is recommended to operate in the horizontal position to avoid

a tipping hazard.

2. CONNECT your water supply vis a garden hose. Supply should be minimum of 5

gallons per minute and have positive pressure.

3. CONNECT a short garden hose to the waste port to carry waste water away from

where you are operating the system.

4. CONNECT the hose you will be using for clean RO water.

5. SLOWLY turn on the water source.

6. FLUSH the system for 5 minutes before use. There should be water coming from

both the waste hose and the RO hose.

7. PLUG the power cord into a GFI 115 volt electrical outlet.

8. START the system with the switch on the pump motor.

9. The system is equipped with a flow restrictor on the waste stream. This limits the

waste to approximately 2.5 gallons per minute and applies appropriate back

Need help?

Do you have a question about the SK PRO Series and is the answer not in the manual?

SK PRO Series Specifications

General

Crucial warnings about system operation, including waste water flow and pump dry running.

Step-by-step guide for system setup, connection, flushing, and operation.

Guidance on checking sediment filter and estimating carbon cartridge replacement based on usage.

Information on membrane lifespan, freeze protection, and recommended replacement procedures.

Details on the one-year warranty for workmanship and parts, excluding membranes.

Instructions for inspecting shipments, reporting issues, and filing freight claims.