Need help?Do you have a question about the Skar RP-4500.1D and is the answer not in the manual?
General| Amplifier Class | D |
|---|---|
| Number of Channels | 1 |
| RMS Power @ 1 Ohm | 4500 Watts |
| RMS Power @ 4 Ohms | 1500 Watts |
| Total Harmonic Distortion (THD) | < 0.1% |
| Input Sensitivity | 6V - 0.2V |
| Subsonic Filter | 10 Hz - 50 Hz |
| Bass Boost | 0 - 12 dB |
| Bass Boost Frequency | 45 Hz |
| Input Terminal Size | 4 Gauge |
| Phase Shift | 0° - 180° |
| Peak Power | 9000 Watts |
| Signal to Noise Ratio | 90 dB |
| Damping Factor | 100 |
| RMS Power @ 2 Ohms | 3000 Watts |
| Fuse Rating | 300 Amp |
Instructions for connecting the amplifier's power terminal to the +12V source, emphasizing external fuse use.
Instructions for locating and connecting the amplifier's ground terminal to the vehicle frame for low resistance.
Guidance on connecting the remote turn-on cable from the switched +12V source to the amplifier's REM terminal.
Steps to connect two amplifiers for a strappable setup, setting master/slave switches and connecting RCA cables.
Diagram and steps for connecting speakers and power in a strappable amplifier configuration.
Check connections, cables, fuses, and speakers to resolve no sound issues.
Troubleshoot overload, overheat, short circuits, DC offset, and voltage issues triggering protection mode.
Adjust input level, check speaker quality, ground contacts, RCA jacks, and engine noise.
Check speaker cables and polarity for poor bass response issues.
To Next Page
