Ski-Doo Mach Z User Manual

Section 06 ELECTRICAL
Sub-Section 05 (ELECTRIC STARTER)
06-05-9
TYPICAL
1. New
2. Wear limit
Overrunning Clutch
The pinion of the overrunning clutch should turn
smoothly in the clockwise direction, and should
not slip in a counterclockwise direction. If defec-
tive, replace.
Check the pinion teeth for wear and damage. If
defective, replace.
SOLENOID SWITCH
Inspect connections and clean as necessary. Sole-
noid switch condition can be checked with an
ohmmeter. Install test probes on large connec-
tors of solenoid when it is activated (+ on RED /
GREEN wire and – on solenoid body).
IMPORTANT: No current must be present on
large cables when using ohmmeter, otherwise
meter could be damaged.
A03E05A
2
1

Ski-Doo Mach Z Specifications

General

Engine Displacement	899 cc
Horsepower	180 hp
Track Length	137 inches
Track Width	15 inches
Cylinders	2
Engine Stroke	2-Stroke
Cooling	Liquid
Fuel System	Electronic Fuel Injection (EFI)
Seating Capacity	1
Fuel Capacity	10.6 gallons
Brake System	Hydraulic