Ski-Doo MX Z 440 - Page 82

Section 04 ENGINE
Sub-Section 01 (503 ENGINE TYPE)
04-01-2
ENGINE REMOVAL AND
INSTALLATION
Disconnect or remove the following :
WARNING : Before disconnecting any
electrical wire in starter system always
first disconnect the BLACK negative battery ca-
ble (on electric starting models).
– negative cable from battery
– Positive cable and wire from starter then from
engine
– belt guard
– drive belt
– drive pulley using appropriate puller, refer to 05-
02 DRIVE PULLEY
– air silencer and carburetor
– impulse line from engine crankcase
– 4-connector housing
– exhaust pipe and exhaust cooling hose
– oil pump inlet tube and plug it
– oil pump cable
– rewind cable : remove starting grip and tie a
knot
;