Why is there no display indication on my SKI Test Equipment?
The lack of display indication on your SKI Test Equipment might be due to a missing auxiliary power supply. Check the auxiliary power supply to resolve this. Alternatively, the main fuse could be defective. In that case, replace the main fuse.
What to do if auxiliary power for sensors is missing in SKI uFLOW 100LSE-QAL?
If auxiliary power is missing for the sensors in your SKI Test Equipment, the fuse for 24VDC may be defective. Replace the fuse for 24VDC. Another possibility is an external short circuit. Check for any external short circuits.
Why are the indicated measured and calculated values not realistic on my SKI uFLOW 100LSE-QAL Test Equipment?
Unrealistic measured and calculated values on your SKI Test Equipment could be due to wrong parameter configuration. Reconfigure the parameters to correct this.
How to fix wrong output current on SKI Test Equipment?
A wrong output current on your SKI Test Equipment may be caused by an incorrect structure, such as 0..20 mA instead of 4..20 mA, or vice versa. Adjust the output current structure accordingly. It could also be due to a wrong zero or span value. Correct the zero or span value.
What to do if SKI uFLOW 100LSE-QAL Test Equipment does not react on the Pt100 input?
If your SKI Test Equipment isn't reacting to the Pt100 input, it could be due to a wrongly chosen Sensorbyte. Select the correct Sensorbyte. Another potential cause is that the DIP-switches are in the wrong position. Correct the DIP-switch settings.
Why SKI uFLOW 100LSE-QAL does not react on the frequency input?
If your SKI Test Equipment isn't reacting to the frequency input, it might be because the Sensorbyte was chosen incorrectly. Select the correct Sensorbyte. Also, the setting of the jumper might not fit the signal. Adjust the jumper setting.
What to do if SKI Test Equipment does not react on the current inputs?
If your SKI Test Equipment isn't reacting to the current inputs, it could be because the Sensorbyte was chosen incorrectly. Select the correct Sensorbyte.
General| Brand | SKI |
|---|---|
| Model | uFLOW 100LSE-QAL |
| Category | Test Equipment |
| Language | English |
To Next Page