When installing a bit, insert the shank of the bit
well within the collet. If the bit is not inserted
deep enough, the grip of the collet over the bit is
reduced and the loss of control is increased.
Do not run the tool while carrying it at your
side. A spinning bit could become entangled
with clothing and injury may result.
Do not use dull or damaged bits and
accessories. Dull or damaged bits have a
greater tendency to bind in the workpiece.
Some dust created by
power sanding, sawing,
grinding, drilling, and other construction
activities contains chemicals known to
cause cancer, birth defects or other
reproductive harm. Some examples of
these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement
and other masonry products, and
• Arsenic and chromium from chemically-
treated lumber.
Your risk from these exposures varies,
depending on how often you do this type of
work. To reduce your exposure to these
chemicals: work in a well ventilated area, and
work with approved safety equipment, such
as those dust masks that are specially
designed to filter out microscopic particles.
9
!
WARNING
To Next Page
