8
Do not drill, fasten or break into existing
walls or other blind areas where electrical
wiring may exist. If this situation is
unavoidable, disconnect all fuses or circuit
breakers feeding this worksite.
Battery tools are always in an operative
condition. Be aware of the possible hazards.
Always wear safety goggles or eye
protection when using this tool.
Secure the workpiece, never hold it in your
hand or across legs. The drilling action may
cause you to lose control of the
workpiece and injury may occur.
Do not insert two bits into a
single Bit Magazine slot. The
second bit may eject forcefully when the Sliding
Switch is pushed to the forward position.
When installing a bit, insert the shank of the bit
well within the collet. If the bit is not inserted
deep enough, the grip of the collet over the bit is
reduced and the loss of control is increased.
Do not run the tool while carrying it at your
side. A spinning bit could become entangled
with clothing and injury may result.
Do not use dull or damaged bits and
accessories. Dull or damaged bits have a
greater tendency to bind in the workpiece.
Some dust created by
power sanding, sawing,
!
WARNING
!
WARNING
To Next Page
Loading...
