Skil LL9000 - User Manual

Owner’s Manual
Model: LL9000
WARNING
To reduce the risk of injury, the user must read and understand
the Operator’s Manual before using this product. Save these
instructions for future reference.
Handle
Center
Column
¼’’ -20UNC
Screw
Locking
Knob 2
Adjustable Foot
Mounting
Plate
Locking
Knob 3
1/4’’ Screw
Platform
Flip Lever
Crank
Locking
Knob 1
Using With the Tripod
NOTE:
The tripod provides a stable, height-adjustable support (up to 43 inches). It
may be utilized on a compact hand-held tool that includes a ¼’’ -20 UNC threaded
mounting hole that will not cause the assembly tip tip-over after mounting.
•
Thread the ¼” -20 UNC tripod screw into the ¼” -20 UNC threaded mounting hole
on your tool. Secure your tool with the 1/4’’ screw platform on the tripod.
•
Loosen locking knob 1. Rotate the crank until the desired height is attained.
Tighten locking knob 1 to lock the center column in position (FIG. 1).
Fig. 1
Manually raise the column to the
height desired.
•
Loosen locking knob 2. Adjust the
mounting plate to the desired position;
the maximum adjustment scale is 90°.
After adjustment, tighten locking knob
2 to lock the mounting plate in position
(FIG. 2).
•
Loosen locking knob 3 to pan the head left or right. The maximum adjustment
scale is 360°. After adjustment, tighten locking knob 3 to lock the position
(FIG. 3).
360
o
Fig. 3
•
Loosen the handle by twisting it
counterclockwise. The mounting plate
can be tilted by moving the handle up or
down; the maximum adjustment scale
is 360°. After adjustment, tighten the
handle clockwise to lock the position
(FIG. 4).
•
Open the 3 flip levers on one leg to
release that leg for adjustment. Extend
the leg to the proper height. Close the
levers to lock the leg in position. Repeat
for the other two legs (FIG. 5).
Tripod
90
o
Fig. 2
360
o
Fig. 4
Fig. 5

Summary

Using the SKIL LL9000 Tripod

Adjusting Center Column Height

Loosen knob 1, rotate crank for desired height, then tighten knob 1 to secure.

Adjusting Mounting Plate Angle

Loosen knob 2, adjust mounting plate up to 90°, then tighten knob 2 to lock.

Panning Head Movement

Loosen knob 3, pan head left/right up to 360°, then tighten knob 3 to lock.

Tilting Mounting Plate

Loosen handle, tilt plate up/down (360°), then tighten handle to lock.

Adjusting Tripod Leg Height

Open leg levers, extend leg, close levers to lock. Repeat for all legs.

Skil LL9000 Specifications

General

Brand	Skil
Model	LL9000
Category	Camera Accessories
Language	English