Basic setting14
• If an external audio source is connected via AUX-IN, which is equipped with an
adapter for external power supply, it can occur that the audio signal is interrupted.
This depends on the quality of the adapter which is used.
• The loudspeakers in the vehicle are matched to a power output of the radio of
4x20 W.
• For the equipment sound system*, the loudspeakers are matched to a power
output of the amplifier of 4x40°W + 6x20 W.
Range selector key SETUP
Main Setup set-ups (Setup)
– Press the range selector key to open the main Setup Setups.
– Select the area for which you wish to change the set-ups or carry out
set-ups by pressing on your selection.
– Press on the function key , to switch back to the last selected Setup.
Overview of the set-up Setups
- When in the radio mode, carry out set-ups for the function of the arrow
keys, for the displayed memory keys, the memory list and the traffic reports.
- Determine the set-ups for the play and display of MP3 data and activate
or deactivate the external audio sources.
- Change the system set-ups such as voice response and time and cancel
or delete stored set-ups in individual areas.
- Select preferred TMC station and determine the area for TMC
announcements.
- Adjust the brightness of the screen and select/deselect the confirmation
tone for the keystroke.
- Update the phone book in the unit, delete all call lists and modify the
assignment of the shortcut keys.
Setup Radio
Call up the Setup Setup Radio by pressing the selector key and the
function key . Press on the function key or on the func-
tion key to determine from which list in the radio mode the
stations are to be selected with the arrow keys. If the is
selected, only stored stations from the memory list are called up.
“Memory” is displayed at the top left in the main Setup RADIO.
Select station keys for display
– Press on the function key behind the function key in the
Setup Setup Radio.
– In the pop-up window, press and select the station keys to be
displayed in the main Setup RADIO.
Switching the RDS function on or off (RDS regional)
– Press on the function key and select a set-up in the
opening pop-up window.
– Press on the function key , doing so will always choose the
frequency for the radio station heard, which offers the best reception
at the present time.
– When pressing on the function key , the unit attempts to hold a
radio station emitting regionally long enough until the reception
quality is so bad, that there is a risk of a program loss.
Delete memory list
– In the Setup Setup Radio move the sliding regulator to the bottom to
display the function key .
– Press the function key and confirm the following
safety interrogation in order to erase all radio stations stored in the
memory list.
SETUP
Radio
Media
System
Traffic program
Display
Phone
SETUP
Radio Station list
Memory list
Memory list
Station keys
RDS regional
Automatic
Fix
Delete memory list
Delete memory list
s3p4.a.book Page 14 Friday, March 13, 2009 3:04 PM
To Next Page
Loading...
Need help?
General
