SKP Pro Audio VZ-100A - User Manual

Electronically balanced inputs accepting standard XLR male connectors with +48V Phantom Power.

Unbalanced input for use with unbalanced mics or high impedance signals like decks.

Break point for inserting external signal processors like compressors into the signal path.

Adjusts input sensitivity of each channel to maintain a constant signal level.

Boost or cut control for frequencies at 12KHz and above, affecting treble and clarity.

Boost or cut control centered at 2.5KHz for shaping midrange frequencies of the sound.

Line input for Left, Right stereo signals or mono input to both sides.

Adjusts input sensitivity of each channel to maintain a constant signal level.

Boost or cut control for frequencies at 12KHz and above, affecting treble and clarity.

Boost or cut control centered at 2.5KHz for shaping midrange frequencies of the sound.

Boost or cut control for frequencies at 80Hz and below, affecting bass and punch.

Controls signal routing for post signal as send or effect.

Adjusts volume for AUX sound sending and returning to the utilized jack.

Adjusts echo sound volume for sending to the effect panel's send jack.

Adjusts echo repeat frequency to prevent howling, ensuring proper sound.

Interface for selecting and adjusting internal digital multi-effects programs.

Buttons to advance or go back through programs, with hi-speed option.

Control for adjusting the signal level of echo repeats and external effects.

2X7-band graphic equalizer for precise tone shaping of the main stereo output.

Master fader for adjusting the volume of the left and right main outputs.

Jacks for connecting external effect units or monitoring devices to the mixer.

Jack for connecting headphones for monitoring the mix and channel signals.

Switch to enable the TAPE IN signal to be routed to the stereo bus.

Input jack for connecting a cassette deck for playback.

Input jack for connecting a cassette deck for recording the mixed output.

Main output jacks (XLR & 1/4") for connecting to main amplifiers or speakers.

Output jacks for Group 1-2 busses, allowing separate routing of submixes.

The main switch to turn the mixer on and off for operation.

Connector for the AC power supply cord (120V or 230V).

Jacks for connecting external speakers to the mixer's amplifier output.

Detailed technical specifications for mono inputs, line inputs, EQ, and master section.