Need help?Do you have a question about the SKP Pro Audio VZ 194 and is the answer not in the manual?
Do not remove covers; servicing by qualified personnel only.
Avoid exposure to rain or moisture to prevent electric shock.
Keep sensitive equipment away from amplifier to prevent hum due to magnetic fields.
Standard XLR input for microphones; gain adjustable 10-60dB.
1/4" jack for unbalanced/balanced line signals from instruments.
Engage to cut input signal below 75Hz.
Adjusts input sensitivity from 10dB to 60dB.
Provides ±15dB fixed EQ at 12KHz.
Offers ±15dB cut/boost with center detent.
Semi-parametric EQ, sweepable 100Hz-8KHz.
Provides ±15dB fixed EQ at 80Hz.
Auxiliary send for effects/monitoring and signal source selection.
Integrated 32-effect processor (reverb, chorus, delay).
Balances signal between left and right buses.
Enables mono PFL bus for gain setting.
Routes signal to ALT3-4 bus.
Controls channel signal volume.
Connect cassette decks for playback/recording.
Line inputs for specific stereo channels.
Cuts signal to the control room output.
Main audio output to speakers/amplifier.
Adjusts ±15dB at 3KHz for mid and high frequencies.
Adjusts ±15dB at 500Hz for mid and low frequencies.
Connect external signals to the DSP input.
Output jacks for auxiliary and FX signals.
Input jacks for auxiliary and FX signals.
24-bit stereo, 32-effect processor.
Adjustable 7-band graphic equalizer.
Engages or disengages the graphic equalizer.
Provides +15dB gain for Aux and FX sends.
Pre-Fader Level monitoring for Aux and FX.
Adjusts output levels for Aux, FX, and ALT3-4 buses.
Controls the main Left and Right output levels.
For auditioning mix playback from tape.
ALT3-4 output monitoring.
Controls the ALT3-4 bus signal level.
Adjusts headphone output and monitoring levels.
Output for 2-track devices.
Controls the main mix output level.
Pre-Fader/Pre-EQ insert points for channel processing.
Insert points and outputs for the ALT3-4 bus.
Insert points for the main mix.
Balanced and unbalanced main output connectors.
Selects main output operating levels (-10dBV/+4dBU).
Activates +48V phantom power for microphone inputs.
Engages power for the mixer circuitry.
Adjusts signal level sent to the internal amplifier.
Balanced input for amplifier signals from sources.
Connects to passive speakers via binding posts or Speakon connectors.
Chooses between 115V and 230V input voltage.
Mains power connection and fuse protection.
Turns the entire unit on or off.
General| Type | Analog |
|---|---|
| USB Interface | No |
| EQ Bands | 3-band |
| Aux Sends | 2 |
| Phantom Power | Yes |
| Outputs | 2 x XLR, 2 x TRS |
| EQ | 3-band |
To Next Page
