SKS-Kinkel Elektronik GmbH
Support-Hotline: +49 (0) 2661 98088 112
E-Mail: support@sks-kinkel.de
Document art. no. 97011700
To open the door following a conversation, press the door open key once. The time frame to open
the door is 2 minutes long and starts with the first time the bell is rung.
Please note that the door opener may only be activated after the doorbell has rung.
3.7 Changing the ringtone of the doorbell
Keep the tone key pressed for some time to change the ringtone of the doorbell. At the same time
briefly tap on the door open key within 1.5 seconds. This key combination will change the ringtone
of the doorbell. Every time you tap on the door open key another ringtone will be played. When
the desired melody sounds, release the button. The selected ringtone will then be the default
setting.
There is a choice of 8 ringtones for the house call and 4 ringtones for the floor call. The ringtone for
the house call signals that the intercom has been activated at the door bell/station at the front door
outside. The floor ringtone signals that the intercom has been activated at the door bell/station
located on the floor inside the building.
3.8 Changing the floor ringtone
To change the ringtone for the floor bell, keep the tone key pressed for some time. Within 1.5
seconds, and in addition to pressing the tone-image-key, it is necessary to keep the door open
key pressed for the same amount of time in order to change the ringtone for the floor bell. If both
keys are kept activated, another ringtone will be played. When the desired melody sounds, release
the button. The selected ringtone will then be the default setting.
There is a choice of 8 ringtones for the house call and 4 ringtones for the floor call. The ringtone for
the house call signals that the intercom has been activated at the door bell/station at the front door
outside. The floor ringtone signals that the intercom has been activated at the door bell/station
located on the floor inside the building.
3.9 Light and special function key
Two keys may be used for special functions. In this way, it is possible to have a variety of switch
functions using the S and light key in combination with a bus actuator module or a switch actuator.
Press the selected key until an acoustic signal confirms that the function has been executed.
Please note that the function „ Light and special function key “ is only available for the special version
of the indoor station.
To Next Page
Loading...
General