SkyArtec WASP X3 User Manual

Crucial information regarding the nature and safe operation of RC models.

Essential safety precautions and guidelines for operating the helicopter.

List of recommended tools, adhesives, and lubricants for assembly.

Steps for assembling frame connector, paddle, and compensator sets.

Instructions for installing the compensator and rotor holder components.

Guide for installing pitch shifter, compensator, and main blade sets.

Steps for installing motor, main shaft mount, and guide pulley.

Installing landing gear, main gear, electronic equipment, and gear tray.

Schematic diagram illustrating belt pulley operation.

Procedure for installing tail rotor holder and control arm.

Instructions for tail gear box, boom, and tail rotor assembly.

Introduction to the SKY706V transmitter's controls and functions.

Explanation of LED indicators on transmitter and receiver.

Procedure for receiver setup and transmitter-receiver code pairing.

Procedure to restore the remote control to factory default settings.

Guidance on adjusting push-rod lengths for proper helicopter control.

Method for measuring and adjusting main blade balance.

Setting pitch and throttle limits for normal and 3D flight modes.

Advice on adjusting pitch based on motor power for optimal performance.

Explanation of pitch control mechanics based on stick movements.

Procedure for adjusting main blade tracking for stable flight.

Testing helicopter control responses in Mode 1 (right throttle).

Essential checks and notices for beginners before flying.

Procedure for safely starting and stopping the helicopter motor.

Practicing throttle, directional control, and trim adjustments for stable flight.

Diagnosing and resolving blade tracking and hovering stability issues.

Addressing problems with gyro sensitivity and tail rotor control.

Instructions for operating Li-Po batteries and chargers safely.

Key points for checking the main rotor assembly for optimal performance.

Steps for properly turning the transmitter on and off.