skybar Wine System - Bottle Installation and Fit Issues

23
skybarhome.com
22
TROUBLE-
SHOOTING
TROUBLE-
SHOOTING
Problem
Dispensing/Pouring
A wine bottle is securely
installed but preservation
mode is not working.
Recommended Steps
• Ensure the Pour Tip is securely in place
on the Pour Spout. If you have reinstalled
the Pour Tip, reset the preservation
mode by opening and closing the door
after you have reinstalled the Pour Tip.
Preservation should begin and the amber
light should illuminate. (See page 17.)
• Remove the Pour Tip by sliding it out from
the Pour Spout. This will allow any
remaining liquids to flow out and air and
water to pass through the Bottle Pour
Assembly for cleaning. (DO THIS OVER
THE SINK.)
• Ensure that the wine bottle is installed
correctly onto the Bottle Pour Assembly and
that the Bottle Pour Assembly is securely
engaged into the Chilling Chamber.
• Ensure that the Pour Tip is installed onto the
Pour Spout properly and is securely
tightened.
• Clean the Bottle Tube and the Pour Tip by
running clean water through the system or
following the cleaning instructions.
(See page 18.) Dry all parts and reinstall.
• Replace the Pour Tip and reset the Chilling
Chamber function by opening and closing
the door.
• Ensure that the Pour Tip is installed onto
the Pour Spout properly and is securely
tightened.
• Clean the Pour Tip. (See page 18.)
• Replace the Pour Tip and reset the Chilling
Chamber function by opening and closing
the door.
Wine is pouring slowly
Problem
Dispensing/Pouring
There are bubbles moving
from the Bottle Tube into
the bottle of wine.
Recommended Steps
Note: The One Wine System is
attempting to preserve your wine, but the
seal is not closed, which is essential
to enabling it to preserve.
• Ensure that the Pour Tip is securely
tightened to the Pour Spout.
• Ensure that the O-ring is in place on the
Pour Tip. If the O-ring is missing, you
will need to replace the Pour Tip.
• Clean the O-ring and the Pour Spout
and recheck the seal.
• Ensure that the Bottle Lock Lever is in the
vertical (open) position, enabling you to
insert the Bottle Tube fully into the bottle.
• Press the Bottle Lock Lever into the
horizontal (closed) position to engage it to
the bottle.
• If your wine bottle has a screw cap and not
a cork, use the Bottle Adaptor provided by
installing it into the bottle first and then
insert the Bottle Pour Assembly.
Note: Remember to remove the Bottle
Adaptor from the Bottle Pour Assembly
when the bottle is empty. It can be reused
multiple times.
• Some unusually sized bottles – either
very tall or very wide – may not fit into
the Chilling Chamber, which is sized for
standard 750ml bottles.
The wine bottle will not
securely install onto the
Bottle Pour Assembly.
Bottle Will Not Fit
The bottle is secured to the
Bottle Pour Assembly, but
will not fit into the Chilling
Chamber.
The Pour Tip drips or has
turbulent flow.