EasyManua.ls Logo

Skybrake DD2+ User Manual

Skybrake DD2+
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
versija 01, 1.06.2008_120114
PRODUCT DESCRIPTION
SKYBRAKE DD2+ is a high security level vehicle protection
system with an anti-theft function for both parked and moving
vehicles. A vehicle equipped with this immobilizer can only be
used if the personal transceiver (PT) is within range, either inside
the vehicle or no further than 2 m away. If the engine is switched
on without the PT, the engine will operate as shown below:
After which it will be immediately immobilized and the system
will warn the driver by buzzer signals and ashing of the status
LED (if installed).
Depending on DD2+ settings, after switching on the ignition
the device will warn the driver of the presence of the PT by a
buzzer and LED signals:
USING THE PRODUCT
If you wish to drive, the PT of the SKYBRAKE DD2+ immobilizer
must be located inside the vehicle.
If the SKYBRAKE DD2+ is equipped with motion detector, the
system allows you to start the engine without the PT, but at
each attempt to drive, the engine will be immobilized. After the
engine’s immobilization, the system allows you to start the engi-
ne again by turning o and on the ignition, but at each attempt
to drive, the engine will be immobilized again. If the engine is
started without the PT more than 8 times, the system becomes
immobilized until the PT is within range or the personal emer-
gency disabling code (PIN code) is used.
If SKYBRAKE DD2+ is equipped with motion detector, be-
fore driving the vehicle, wait for the signals conrming the
presence of the PT!
If the SKYBRAKE DD2+ is not equipped with motion detector or
the motion detector is turned o, the system allows you to start
the engine without the PT, but after 50 seconds the engine will
be immobilized. Driving the vehicle is not possible until the PT
is within range or the personal emergency disabling code (PIN
code) is used.
SKYBRAKE DD2+ warns the driver of the non-presence of
the PT in the receiving range in the following order:
1. Activation: The time during which the vehicle ignition is tur-
ned on and the system is waiting for a signal from the PT, there
are no sound or light indications, and the vehicle’s engine is not
immobilized. Activation time is 18 seconds.
2. Warning: The warning signals consists of two parts:
a) Initial warning signals. The time during which, the system
warns the vehicles driver about the non-presence of the PT wit-
hin receiving range. Long sound signals are emitted; the vehicle
engine is not immobilized. The length of the initial warning sig-
nals is 1 minute.
b) Final warning signals. The time during which, the system
warns the vehicle’s driver about the non-presence of the PT wi-
thin receiving range. Brief and regular light and sound signals
are emitted; the vehicle engine is not immobilized. The length
of the nal warning signals is variable (the factory setting is 32
seconds).
3. Panic: The time during which the system warns the vehicle’s
driver about the non-presence of the PT within receiving range.
Uninterrupted series (5 signals) of sound and light signals are
emitted, the vehicle engine is immobilized.
If while you are driving warning signals start emitting inside the
vehicle, immediately stop by the side of the road in line with
road safety rules and switch o the ignition. Make sure that the
PT is within range. Turn on the ignition and wait for the signals
conrming that the PT has been located. If warning signals indi-
cate that the PT is out of range, immediately contact the system
installer or manufacturer.
If SKYBRAKE DD2+ is equipped with motion detector and panic
mode is activated while the vehicle is in motion, vehicle’s engi-
ne will only be immobilized when the vehicle’s speed will be 0
km/h; remains the same at least 10 seconds and motion begins
again. If system is not equipped with motion detector and panic
mode is activated, the engine will be immobilized immediately
as panic mode starts.
When the SKYBRAKE DD2+ immobilizer has blocked the engine
you will hear a series of uninterrupted signals.
Anti-theft function.
The anti-theft function will automatically proceed when the PT
is taken out of range with the ignition switched on. For the rst
50 seconds, the system will continue to wait for a signal from the
PT. Then the driver will be warned (warning algorithm) – activa-
tion, warning and panic. If the motion detector(if equipped) is
turned on, the engine will be immobilized when vehicle’s spe-
ed becomes to 0 km/h and as soon as motion starts again. If
the motion detector is turned o , the engine will be blocked as
Auto Immobilizer
SKYBRAKE DD2+
User manual
Engine Anti-theft Motion
operation function detector
1) 50 seconds (programmable from 35 to 65 sec) Switched o Switched o
2) Until the car begins moving Switched o Switched on
3) 50 seconds (programmable from 35 to 65 sec) Switched on Switched o
4) Until the car begins moving Switched on Switched on
Sound signal Anti-theft Motion
and light diode conrmation function detector
1) one time short ( 0.1 sec), Switched o Switched o
2) one time long (0.3 sec) Switched o Switched on
3) silence Switched on Switched o
4) two times Switched on Switched on

Other manuals for Skybrake DD2+

Question and Answer IconNeed help?

Do you have a question about the Skybrake DD2+ and is the answer not in the manual?

Skybrake DD2+ Specifications

General IconGeneral
BrandSkybrake
ModelDD2+
CategoryCar Alarm
LanguageEnglish

Summary

PRODUCT DESCRIPTION

Vehicle Protection System

High security vehicle protection with anti-theft for parked/moving vehicles. PT required for use.

Engine Operation Modes

Details engine operation based on PT presence and motion detector status.

Driver Warnings and Signals

Describes buzzer and LED signals confirming PT presence or absence.

USING THE PRODUCT

Driving Requirements

PT must be inside the vehicle to drive. Immobilization occurs if PT is absent.

Immobilizer Behavior with Motion Detector

Explains system immobilization when PT is absent and motion is detected.

System Warnings for PT Absence

Details the sequence of activation, warning, and panic signals indicating PT non-presence.

ANTI-THEFT FUNCTION

Anti-Theft Activation

Anti-theft function activates automatically when the PT is out of range with ignition on.

Emergency System Disabling

PIN Code Entry Procedure

Step-by-step guide to disable the system using a special PIN code without the PT.

CHECKING THE PERSONAL TRANSCEIVER (PT)

PT Components and Battery

Details PT composition, battery life, and assembly notes.

Troubleshooting PT Immobilization

Steps to check system function if the engine is immobilized despite PT presence.

GUARANTEE PERIOD

Warranty Terms and Conditions

Details the 24-month guarantee, its validity, and exclusions.

Related product manuals