Skyjack SJ46AJ User Manual

SJ46AJ SJ51AJ SJ63AJ
December 2007 Page 23
It is the responsibility of the operator to read, completely understand and follow all
instructions and warnings contained in this operating manual and on the MEWP.
FAMILIARIZATION
2.3-8 Engine Compartment
- Ensure all compartment latches are secure
and in proper working order.
• Main Power Disconnect Switch
- Turn main power disconnect switch to
“ ” off position.
- Ensure there are no loose or missing
parts and there is no visible damage.
- Ensure all cables are secure and switch
is in proper working condition.
• Battery
Proper battery condition is essential to good
engine performance and operational safety.
Improper uid levels or damaged cables and
connections can result in engine component
damage and hazardous conditions.
WARNING
Explosion hazard. Keep flames and
sparks away. Do not smoke near
batteries.
WARNING
Battery acid is extremely corrosive -
Wear proper eye and facial protection as
well as appropriate protective clothing.
If contact occurs, immediately ush with
cold water and seek medical attention.
1. Check battery cases for damage.
2. Clean battery terminals and cable ends
thoroughly with a terminal cleaning tool or
wire brush.
3. Ensure all battery connections are tight.
4. If applicable, check battery uid level. If plates
are not covered by at least 13 mm (1/2”) of
solution, add distilled or demineralized water.
5. Replace battery if damaged or incapable of
holding a lasting charge.
WARNING
Use original or manufacturer-approved
parts and components for the MEWP.
• Charge Indicator
- Ensure there are no loose or missing
parts and there is no visible damage.
• High Pressure Filter
- Ensure housing is secure and shows no
visible damage or leakage.
• Hydraulic Pumps
- Ensure there are no loose or missing
parts and there is no visible damage.
- Ensure all bolts are properly tightened.
- Ensure all ttings and hoses are properly
tightened and there is no evidence of
hydraulic leakage.
• Muffler and Exhaust
- Ensure mufer and exhaust system are
properly secured, with no evidence of
damage.
• Engine Pivot Tray
- Ensure there are no loose or missing
parts and no visible damage to the
engine pivot tray. For models SJ46AJ
and SJ51AJ, ensure that quick release
pin is in place.
• Engine Oil Level
- Maintaining the engine components
is essential to good performance and
service life of the MEWP.
WARNING
Beware of hot engine components.
Check oil level on dipstick
- Oil level should be in the “safe” zone.
Add oil as needed. Refer to Table 4.2b for
recommended oil type.
• Engine Air Filter
- Ensure there are no loose or missing
parts and there is no visible damage.
• Fuel Leaks
- Ensure that there no fuel leaks.
DANGER
Engine fuels are combustible. Inspect
the MEWP in an open, well-ventilated
area away from heaters, sparks and
ames. Always have an approved re
extinguisher within easy reach.
- Ensure fuel tank, hoses and ttings show
no visible damage and no evidence of
fuel leakage.
Section 2 - Familiarization Visual & Maintenance Inspection

Skyjack SJ46AJ Specifications

General

Brand	Skyjack
Model	SJ46AJ
Category	Boom Lifts
Language	English