Skyjack SJ46AJ User Manual

SJ46AJ SJ51AJ SJ63AJ
December 2007 Page 33
It is the responsibility of the operator to read, completely understand and follow all
instructions and warnings contained in this operating manual and on the MEWP.
FAMILIARIZATION
• Test Base Emergency Stop
1. Push in “ ” emergency stop button.
Result: Engine should shut down and
MEWP functions should not operate.
2. Pull out “ ” emergency stop button and
restart engine.
• Test Function Enable Switch and All Boom
Functions
WARNING
Ensure that there are no personnel or
obstructions in test area and there is
sufcient room for boom to swing.
1. Do not hold “ ” function enable switch.
Attempt to activate each boom and
platform switch.
Result: All boom and platform functions
should not operate.
2. Hold “ ” function enable switch and
activate each boom and platform function.
Result: All boom and platform functions
should operate as selected.
• Test Platform Self-leveling
1. Lower boom to stowed position.
2. Adjust platform to a level position using
platform leveling switch.
3. Raise “ ” and lower “ ” main
boom through a full cycle.
Result: Platform should remain level at all
times.
• Test Emergency Power
1. On base control console, push in “ ”
emergency stop button to turn engine off.
2. On platform control console, push in “ ”
emergency stop button.
CAUTION
When operating on auxiliary power, do
not operate more than one function
at a time to avoid overloading 12-Volt
auxiliary pump motor. Do not use
emergency power unit continuously
for more than two minutes for models
SJ46AJ/SJ51AJ and for more than three
minutes for model SJ63AJ.
NOTE
Base Control Console
Emergency
Stop
Base/Off/Platform Key
Switch
Start/Function Enable/
Emergency Power Switch
Section 2 - Familiarization Function Tests

Skyjack SJ46AJ Specifications

General

Brand	Skyjack
Model	SJ46AJ
Category	Boom Lifts
Language	English