Skyjack SJ46AJ User Manual

SJ46AJ SJ51AJ SJ63AJ
December 2007 Page 57
Section 3 - Operation Start Operation
3.8-11 To Drive Forward or Reverse
CAUTION
When you are in the platform and
positioned over an axle, the direction
you are facing will be forward.
1. Depress and hold footswitch.
2. Push and hold drive/steer controller in this
direction “ ” to drive forward or “ ” to drive
backward.
3. Release controller handle to stop.
CAUTION
The drive orientation can change when
the turret is swung 90 degrees off center
of the normal driving position (roughly
when boom is swung past the rear tire).
Drive re-orientation will not occur while
driving and rotating until the joystick
is released for 6 seconds or when the
footswitch is released.
CAUTION
When driving on a slope:
• Torque Switch MUST be in high
torque mode.
• DO NOT exceed the rated
gradeability listed in Table 4.2a.
• Ensure fuel level is above half to
avoid a possible stall condition.
3.8-12 To Steer
1. Depress and hold footswitch.
2. Press rocker on top of drive/steer controller in this
direction “ ” to steer left or “ ” to steer right.
NOTE
Driving and steering may be active at the
same time.
3.8-13 To Move Jib Up and Down Using
Platform Control Console
1. Depress and hold footswitch.
2. On jib up/down switch, select “ ” to move jib
up or “ ” to move jib down. Release switch
to stop.
3.8-14 To Move Riser Up and Down Using
Platform Control Console
1. Depress and hold footswitch.
2. On riser up/down switch, select “ ” to move
riser up or “ ” to move riser down. Release
switch to stop.

Skyjack SJ46AJ Specifications

General

Brand	Skyjack
Model	SJ46AJ
Category	Boom Lifts
Language	English