QUICK GUIDE (EN)
SAT-Receiver MZ-52
Warnings and Cautions
The MZ-52 does not have an on/off switch to completely cut the power supply.
When installing the receiver, inserting the adapter in the wall socket is the last thing you do.
Taking the adapter out of the wall socket is the first thing you do when performing any type of
maintenance or when moving it.
Use only the cables and power adapter supplied for the device. The plugs and cables will not
require excessive force to when inserting in the sockets.
If the power adapter, cables or device appear damaged at any time, discontinue use
immediately. Routinely check the condition of the equipment and cables.
Position the device in a well-ventilated area, which is dry, and without risk of food or water
spilling on it. It should be in a temperate environment not near heat sources and flames.
(heaters and candles)
The device needs to be on a stable platform that is not stacked on or underneath other
electrical devices.
If you are using an external hard disk, do not put it on or under the MZ-52.
Device cleaning can be done with a soft, damp cloth after the MZ-52 is turned off from the
power source. The device must be dry before turning it back on.
Never attempt to open the device or insert anything into the ventilation holes.
Nonauthorized repairs and tampering will void your warranty for this device.
To Next Page
Loading...
Need help?
General
