SkylinkHome TB-318 - User Manual

4. TOGGLE MODE (DEFAULT)
Push pad to
toggle on / o
ON
OFF
Pushing the pad from one position to the other will toggle the status of a
load, i.e. when the light is o, pushing the pad will turn on the light, and
vice versa.
To enable or disable the ON/OFF Operation
mode, press and hold the set button for
15 seconds until the LED blinks.
5. ON / OFF MODE
Push the top button to turn on your light and push the bottom to turn it o.
+
Red
LED
SET
Button
CR 2032
SET
Button

Summary

Introduction to Wall Mount Transmitter

Power Up Transmitter

Initial Power and LED Check

Remove battery isolator and press pad to confirm transmitter power and red LED response.

Programming to Receiver Module

Transmit Learn Code

Steps to program a transmitter to a receiver module by transmitting a 'Learn' code.

Wall Mount Transmitter Installation

Mounting Options

Install transmitter using double-sided foam tape or screws for wall mounting.

Toggle Mode Operation

Toggle Functionality

Pushing the pad toggles the load status between on and off.

On;Off Mode Operation

Enable and Use On;Off Mode

Enable mode by holding SET for 15s; use top/bottom buttons for on/off.

Brightness Control Operation

Adjusting Light Brightness

Turn on light, then press and hold pad to adjust brightness up or down.

Erasing Transmitter from Receivers

Self Erase Method

Erase transmitters via a receiver's erase button; procedure does not involve the transmitter.

Erase by Remote Method

Transmit an 'Erase' code from the transmitter to remove programmed receivers.

Battery Replacement

Battery Replacement Procedure

Replace battery when range reduces or LED doesn't flash; follow steps for removal and insertion.

FCC Compliance

Warranty Information

Customer Service and Support

Available Accessories

SkylinkHome TB-318 Specifications

General

Brand	SkylinkHome
Model	TB-318
Category	Transmitter
Language	English