Skype DECT - The Handset and Base Unit

3
Press this to make the
handset ring, if you
cannot remember where
you put it, press it again
to stop the handset
ringing.
Handset Locator Button
Press to end a telephone
call. Press and hold 2-3
seconds to switch the
handset on/off.
INT Ke
y
Press to make an
intercom call (if you
have more than one
handset).
Pause Ke
y
Long press for pause,
short press for “#”
The Handset and Base Unit
Left Ke
y
Right Key
Scrolling Button
Press to enter menu and
sub-menu mode;
Press to confirm selection;
With the key “*” to lock or
unlock the keypad;
Press during a call to mute
the mouthpiece.
Press during programming
to move through the
menu;
Press during a call to
change the volume in the
earpiece.
Press to enter phonebook
menu. Press during
programming to go back
to the previous option;
Press to clear digits from
the display.
End /On-Off Ke
y
Speakerphone Key
Press to turn the
speakerphone ON/OFF
Call /
R
ecall Ke
y
Press to begin and answe
r
a
telephone call.
You can activate Recall
function if your phone is
connected to a PABX, or if
you use Select Services.
Press to transfer an outside
call to another phone.
Char
g
e Li
g
ht
The IN USE light comes
on when you have
connection to the
telephone line.
The CHARGE light comes
on when the handset's
batteries are being
charged.
Note:
Before you can use the handset to make calls for the first time, you will need to
fit and fully charge the batteries for 15 hours.
In Use Light
Sk
yp
eKe
y
In idle mode, you can
press UP key to access
Skype Call List
directly.