Skyrocket Chocolate Pen - Assembly & Filling Pen; Pen Assembly Steps; Filling the Pen with Candy; Molding & Drawing

CLICK
CLICK
CLICK
CLICK
CLICK
CLICK
FILL MODE
1 2
With pen in draw mode, press
draw button until plunger moves
all the way to tip.
3
Dip pen into deep end
of desired color.
4
Push switch up to start
auto-fill cycle.
6
Stir to ensure candy is fully melted
and gently tap on side of tray.
5
Changing Colors or
Removing Hardened Candy
Changing Colors or
Removing Hardened Candy
Assembly & Filling PenAssembly & Filling Pen
CLICK
CLICK
CLICK
CLICK
CLICK
CLICK
CLICK
CLICK
Seal candy into bag and
follow preparation steps 3-6.
1
7
Watch pen filling through
window gauge
8
9 10
11
Gently stir & tap side of tray
while keeping tip submerged
to avoid sucking air.
Wipe tip clean with damp cloth
and snap on drawing tip.
Push switch down (draw mode)
to end auto-fill cycle
Pen will automatically
CLICK off when full.
Disassemble and pull cartridge
and stuck plunger from pen.
Seal into locking bag and place
in warm water for 1 minute.
Remove from bag, then free
candy from cartridge with stir stick.
If candy hardens,
pen will stop working.
NOTE: You may switch back to draw
mode any time during cycle, you do
not need to wait until completely full.
CLICK
CLICK
2 3
54
CLICK
Watch plunger
move towards tip
thru window.
Molding & DrawingMolding & Drawing
Press draw button to make
candy flow from pen.
Fill remainder of shape
with a different color.
(See changing colors on next page)
Place designs in refrigerator
and allow them to harden.
Use the pen to draw shapes.
Use Stir Stick for fine details.
Draw pictures on squares of
wax or parchment paper.
After design has hardened,
carefully peel back paper.
NOTE:
For best
results hold
pen ½ inch
above paper.
1
3
5
2
4
DRAW
MODE
DRAW
MODE
6
Slide plunger into pen, then slide
cartridge over tip of plunger.
Cover with pen door, then lock
in place with retainer ring.
Drain color back
into warming tray,
disassemble &
wipe parts clean
with cloth. Refill
with new color!
CHANGING
COLORS
TAP
TAP
TAP
TAP
To ensure there are no air bubbles:
1. Point pen upwards
2. Tap gently against table
3. Tap draw button until all air is out & you see chocolate.
TIP: Start drawing immediately! Candy will harden within approx 10 minutes of removal from tray.
PRO TIP!