Skytrac DSAT-300 Series - Page 13

SkyTrac Systems Ltd.
Document Revision 01.000 DOC0595 Page 13 of 21
Restricted Proprietary and Confidential Information
17. Slowly clamp the top and bottom enclosures together until they are slightly ajar or
fully shut, similar to similar to Figure 19 .
Figure 19 – Enclosure Assembly Gap
18. Turn the assembly over and fasten the top and bottom enclosures together at 6
places using #4-40 screws from step one.
Warning: Do not exceed a torque of 3.2 in-lbs when fastening the enclosure together.