SkyTrac Systems Ltd.
Document Revision 01.000 DOC0595 Page 14 of 21
Restricted Proprietary and Confidential Information
3
DSAT-300I
1. Unfasten and remove the screws from the DSAT-300 at 6 locations using a #1
Phillips head screw driver (screw: Phillips #4-40). Retain the screws for later use.
Figure 20 – Screw Locations
2. Turn the DSAT over and lift the top enclosure from the right side as shown in
Figure
21
, creating a hinge on the left end of the enclosure.
Figure 21 – Unhinging the Enclosures
To Next Page
Loading...
