Skytrac DSAT-300 Series - Factory Reset Procedure; Bluetooth and Wi-Fi Connectivity

SkyTrac Systems Ltd.
Document Revision 01.000 DOC0595 Page 17 of 21
Restricted Proprietary and Confidential Information
8. Take the new battery and tuck its connector underneath the Battery Cross Bar.
Figure 26 – Battery Connector Tuck
9. Bend the Battery Cable around the front face of the Battery as shown in Figure 27.
Figure 27 – Battery Cable Position
10. Position the Battery between the cross bar and mounting foam and ensure that the
battery is tangent to the mounting standoffs of the enclosure.