SkyTrac Systems Ltd.
Document Revision 01.000 DOC0595 Page 18 of 21
Restricted Proprietary and Confidential Information
Figure 28 – Battery Tangent to Mounting Bosses
11. Orient the battery cable and battery’s circuit board upwards in order to avoid
collisions with the modem during assembly.
Figure 29– Battery Cable Orientation
12. Bend the battery cable roughly 180 degrees and push the cable down towards the
enclosure as shown in
Figure 30
. This will ensure that the cable will not collide with the
PCB during installation.
Figure 30 – Battery Cable Deformation
To Next Page
Loading...
