SkyTrac Systems Ltd.
Document Revision 01.000 DOC0595 Page 19 of 21
Restricted Proprietary and Confidential Information
Warning: It is extremely important that the positions of the battery cables are clear of
collisions with the push button connector, battery connectors, and any contact with the
PCB.
13. Repeat steps 9 to 12 for the second battery.
Figure 31 – Battery Installation Complete
14. Connect the battery connectors to their nearest receptacle as shown in
Figure 32
.
During battery connections, ensure that the Iridium cable is looped around the
battery connectors as highlighted in the circled area of the Figure below.
Figure 32 – Battery Connections with Iridium Cable Detour
To Next Page
Loading...
