SkyTrac Systems Ltd.
Document Revision 01.000 DOC0595 Page 20 of 21
Restricted Proprietary and Confidential Information
15. Lower the top enclosure assembly onto the bottom enclosure assembly. Ensure the
power connector and USB receptacle are aligned properly.
16. Pivot the two enclosures at the power connector end as shown in
Figure 33
.
Figure 33 – Imaginary Enclosure Hinge
Warning: Forcing the enclosures together at this point would induce stresses in the PCB
resulting in undesirable deflection.
17. Slowly clamp the top and bottom enclosures together until they are slightly ajar or
fully shut, similar to
Figure 34
.
Figure 34 – Enclosure Assembly Gap
18. Turn the assembly over and fasten the top and bottom enclosures together at 6
places using #4-40 screws from step one.
Warning: Do not exceed a torque of 3.2 in-lbs when fastening the enclosure together.
To Next Page
Loading...
