To Next PageTo Next Page
Need help?Do you have a question about the Skytric UBSF02-8 and is the answer not in the manual?
General| Model | UBSF02-8 |
|---|---|
| Category | Accessories |
| Type | USB Flash Drive |
| Storage Capacity | 8 GB |
| Interface | USB 2.0 |
Instructions for careful assembly by at least two adults.
Guidelines for inspecting, cleaning, and repairing the trampoline.
Rules and tips to reduce the risk of injury during trampoline use.
Critical safety warnings regarding product use and potential hazards.
Recommended practices for safe and effective trampoline operation.
Lay out trampoline parts to form a circle with top rail sections.
Attach leg extensions to the leg base and secure with screws.
Attach leg supports to top rails and secure them with screws.
Fasten the frame with screws and add stabilizers to the legs.
Place the trampoline mat inside the frame before attaching springs.
Attach springs between the mat and frame at quarter points and then evenly.
Lay out the safety pad around the outer edge, covering the springs.
Attach the pad strings to the mat v-rings and outer end of springs.
Insert push buttons into lower poles and attach them to the frame.
Attach upper poles to lower poles, cover with sleeves and caps.
Connect fiberglass rods by clicking them together end-to-end.
Insert fiberglass rod ring into pole caps, aligning spaces.
Connect net to v-rings, weave rope through net and v-rings to secure.
Verify screw tightness, spring security, frame sturdiness, and pad security.
Check net poles, stitching, zipper, hooks, and attachment to rings.
Learn the proper stance, arm swing, and landing for a basic bounce.
Regain control and balance during a jump by bending knees sharply.
Land on hands and knees with a straight back for a four-point landing.
Land on knees with a straight back and use arms for balance.
Land in a flat sitting position and push up with hands to return upright.
