Skytrofa Auto-Injector - Charging and Charger Cable

Troubleshooting and Care
49
Cleaning and Maintenance
Charging the SKYTROFA Auto-Injector
Connect the USB (large end of the cable) to
the charger. Plug the charger into a power
outlet. Connect the Micro-USB (small end
of the cable) to the rear of the auto-injector.
For protection, charge the auto-injector
with the protective cover on. Read more
b
pages 8–9.
Only charge the auto-injector when the
EDWWHU\LFRQLVŴDVKLQJJUHHQRUUHG
Read more
b
SDJHV Ŋ
Do not attempt to use any charging
adaptor or charging cables other than
those included with your auto-injector.
Other adaptors or cables may create
problems and may interfere with device
operation.
Do not clean the auto-injector while
charging.
The auto-injector cannot be used when
connected to the charger.
If a cartridge is inserted in the auto-injector,
the Micro-USB cannot be connected to the
auto-injector. Likewise, a cartridge cannot
be inserted into the auto-injector if the
Micro-USB is connected to the auto-injector.
Charging and Charger Cable