6
• Small round Brush for high level dusng.
• Crevice tool connector
• 3 guer cleaning tools: Standard Dirt Breaker / Daily End Tool / Crevice End
• 2 x Silicone Flexi Tool Holders: 135 & 180 degree
TOP (Coloured Tip)
BASE
1. The coloured band indicates the TOP of EACH POLE—with the Orange
band indicang the highest pole for use with the tool holder.
2. Ease the base of the higher pole, INSIDE the neck of the TOP (coloured
band) of the lower pole. (Male into Female).
3. The HIGHER pole should sit INSIDE the LOWER pole to ensure that the
dirt and debris ows OVER the joint and not into it.
4. To achieve desired height, slot poles together, resng against the side of
a building.
ORANGE TIP: (TOP POLE: Aach Tool Holder)
BASE
COLOURED BAND:
TOP OF POLE
BASE POLE SLOTS INSIDE
BANDED TOP POLE
TOP TIP:
Have a bucket of water handy and ush your poles through at the end of each task
to rinse out any dirt and debris that can get stuck in the joints
To Next Page
Loading...
