13
STEP 13
Next, push the end of one rail out of the net hole, to the outside of the net. Then, insert the rail end into the short
horizontal tube located on the curved tube (7). Repeat this step with an adjacent rail. The smaller end of one rail
should fit inside the larger end of the other rail with both ends inside of the short horizontal tube. Repeat this
process to assemble all rails together. This step may be a little tricky... so grab a friend to help! When you reach
the last curved tube that has not yet been placed, insert it into the leg piece and connect the last rail tubes to
complete the circle.
(7) (7)
Small end
Big end
Big end
Big end
Short horizontal tube
STEP 14
Place the straps that are at the top of the enclosure net over the pole caps (12).
(12)
(4)
Strap
To Next Page
Loading...
