12
STEP 11
Foam for Rail [X6)
11
Unfold the enclosure net attached to the mat, and locate the sleeves sewn
on the inside of the net. Slide a piece of foam (11) into one of the sleeves
inside the net (4).
Repeat this step until all foam pieces have been places inside the sleeves.
ASSEMBLY
STEP 12
Rail (x6)
2
Insert a rail (2) into the foam (11) inside the sleeve. Make sure the rail is
curved inwards. Repeat this step until all of the rail sections have been
inserted into the foam and sleeves.
Make sure the ends are alternating, so one end of the rail will fit inside the
other.
Sleeve
Sleeve
(11)
(11)
Small end
Big end
(2)
Big end
To Next Page
Loading...
