11
STEP 9
Pole Cap (x6)
12
Curved Tube (x6)
7
Insert the bottom (the curved section) of one curved tube (7) into a leg
piece as shown. The tube should be curving in towards the mat, and the
short horizontal piece on the middle of the tube should be facing inwards as
well.
Repeat this step to insert 5 more curved tubes.
STEP 10
Now place one pole cap (12) on top of each curved tube.
Make sure the pole caps are pushed all the way down!
Curves in towards mat
(7)
(12)
To Next Page
Loading...
