3. Lay the Left corner tube(5) and the Middle tube(2) on the ground in the
position as shown, make sure the tubes are turned , so the small holes
(spring hole ) are facing the ground
Insert the Middle tube (2) into the Socket of the Left corner tube(5)
as shown.
4, Insert the Leg Brace(3) into the Leg extension(4) secure with M6 X63mm
Bolt(6), M6 Washer(7), and M6 Locknut(8)
Insert the Leg extension( 4) into the Socket, press down on both legs at the
same time and fully insert them into the Socket secure with M6 X63mm
Bolt(6), M6 Washer(7) and M6 Locknut(8)
Repeat steps 3 and 4 other time to assemble one more leg sections.
the two leg sections B will be completed.
Notice: Do not tighten the Bolt and Nut
6
6
5
3
2
7
7
7
7
7
7
8
6
7
8
8
6
7
8
4
4
3
A
B
2
4
Repeat steps 1 and 2 other time to assemble one more leg sections.
The two leg sections A will be completed
14
To Next Page
Loading...