DualCom Pro 2 Range
Introduction
The DualCom Pro 2 Range offers Installers easier, faster installation of a professional
signalling system with even greater resilience, plus access to CSL Live, our ordering
and management portal.
Using the onboard serial connections, pins triggering or dial capture, DualCom Pro 2
is compatible with a wide range of control equipment including systems installed to
EN50136 & PD6662. The range consists of DigiAir Pro 2 - our single-path solution
that utilises a Radio path or LAN to signal an alarm; and GradeShift Pro 2 - our dual-
path solution that utilises a combination of two Radio paths or one Radio and one
LAN path to signal an alarm.
Figure 1 - DualCom Pro 2
It’s as Easy as 1, 2, 3!
Most DualCom Pro 2 units are ready to go after these few simple steps
To Next Page
Loading...