Need help?Do you have a question about the SlatPro SLAG HOG 67123 SH3G and is the answer not in the manual?
Read all safety warnings and instructions. Unplug tool before maintenance, use protective equipment, avoid wet conditions, keep cord clear.
Tool for removing slag from laser cutting machine slats with horizontal planes. Slats can be steel, stainless steel, or copper. Do not use in wet areas or outside.
Connect only to single-phase AC voltage as indicated on rating sticker. Ensure plug-in receptacle has ground contact and sufficient current capacity.
Keep ventilation slots clear to prevent over-heating.
Details cutter wear and replacement, listing required tools and specific replacement cutter part numbers for different slat gauges.
To Next Page
General