SleepPhones SIMPLE - User Manual

www.SleepPhones.com
1. TURNING ON YOUR SLEEPPHONES
®
SIMPLE MODULE
- Find the button on the SleepPhones
®
Simple module
located inside the headband.
- PRESS and HOLD the button for 3 seconds until you hear
“power on” through the speakers.
2. OPERATING INSTRUCTIONS
VOLUME: Click the button on the SleepPhones
®
Simple module
to change the volume. Each click will increase or decrease the
volume by 15%.
NEXT SONG: Double-click the button to skip to the next song.
TIMER: The default timer is 1 hour. To change the amount of
time a song plays, a long click followed by a short click will
advance the timer options. Each timer option will announce
on the speakers. For example, you will hear, “2 hours until
automatic power off.”
Timer options are:
30 minutes: will play your favorite track for 30 minutes
1 hour: will play your favorite track for 1 hour
2 hours: will play your favorite track for 2 hours
8.5 hours: double click to advance to the next track to nd
the best track that you prefer and you can listen to your
favorite for 8.5 hours
Play once then power off: will ow through all 17 tracks
which are 30 minutes each and power off when it reaches
the last track
Play until batteries are low: will also ow through all 17
tracks, but will keep playing until the battery dies
POWER OFF: The SleepPhones
®
Simple will turn off
automatically according to the timer option.
To turn off the module manually, PRESS and HOLD the button
for 3 seconds until you hear “power off.”
Once set, the system remembers your favorite volume, song and
timer option. It would be possible to use the SleepPhones
®
Simple with a simple press of the button each night.
Quick Start Guide

Summary

Turning On SleepPhones Simple Module

Power On Procedure

Press and hold the module button for 3 seconds to turn on the device.

Operating Instructions

Volume Control

Click the module button to adjust volume by 15% increments.

Next Song Selection

Double-click the button to advance to the next track.

Timer Functionality

Adjust timer options via button clicks; options include 30 min, 1 hr, 2 hr, 8.5 hr, play once, or until low battery.

Power Off Procedure

Device powers off automatically via timer or manually by holding the button for 3 seconds.

Charging Instructions

Connecting for Charging

Connect the module to a USB port using the micro-USB cable to begin charging.

Charging Indicator Lights

A pulsing red light indicates charging; a solid red light means fully charged.

Reconnecting Speakers

After charging, reconnect the speakers to the module via the micro-USB port.

SleepPhones SIMPLE Specifications

General

Connectivity	Wired
Wireless	No
Driver Type	Dynamic
Frequency Response	20Hz - 20kHz
Impedance	32 Ohms
Cable Length	1.5m
Connector	3.5mm
Washable	Yes
Compatibility	Universal (any device with 3.5mm audio jack)