SleepPhones Wireless - Removing the Speakers; Access Speaker Compartment; Extract Speakers and Module; Wash Headband

Reinserting the Speakers
1. The right speaker will have red
stitching. The left speaker will have
green stitching. The softer gray
(fleece) side should be facing in
towards the ear and the coarse (felt)
side should face away from the ear.
2. Insert the speakers, one at a time,
about four inches from the hook &
loop opening on both sides of the
headband.
3. Then insert the Bluetooth®
module into the headband and close
the hook & loop opening.

Removing the Speakers
1. There is a hook & loop opening at
the back of the headband. Open to
reveal the speaker components inside
the headband.
2. Remove the Bluetooth® module
& then pull very gently on the cord to
remove the speakers, one at a time,
from the headband.
3. Once the speakers are removed,
you can machine-wash the headband.
!
1
2
3
1
2
3
Speakers
Check out the instructional video!