14
English
www.slendertone.com
Caring for your unit:
Your unit should not be allowed to get wet or be left in excessive sunlight.
It may be cleaned using a soft cloth, lightly dampened in soapy water. Do
not allow the interior of your unit to become wet. Do not use detergents,
alcohol, spray aerosols or strong solvents on your unit.
Access to the interior of the unit is not required for maintenance purposes.
Note: Using leak-proof batteries is advised. You should never leave the
batteries inside your unit if you do not intend to use it for a long period
of time. If you do, the batteries may leak and damage your unit. You
should be aware that some batteries sold as ‘leak-proof’ can still release
some corrosive substances, which may damage your unit. Under no
circumstance should anything other than the correct type of batteries
(1.5V, AAA) be used with your unit. You should only insert the batteries in
the manner specified in this manual.
Disposing of the pads and batteries:
Used pads and batteries must never be disposed of in a fire but in
accordance with national laws governing the disposal of such items.
N
otes: When the symbol is flashing, the stimulus is significantly
reduced. The signal gradually increases to a peak intensity level at the
start of the contraction phase (ie. ramp up) and gradually decreases to
nothing at the start of the relaxation phase (ie. ramp down).
Environmental Specifications:
Operating range: Temperature: 32 to 95˚F
Humidity: 20 to 65 % RH
Transport & Temperature: 32 to 131˚F
Storage range: Humidity: 10 to 90 % RH
Product Type:
517-US
Intended use: Muscle stimulator
A
ccessories
When ordering new pads, you should only use those carrying the
SLENDERTONE brand. Any others may not be compatible with your unit
and could degrade the minimum safety levels.
SLENDERTONE ABS5 Adhesive Pads:
Each pad pack contains:
• 1 large adhesive pad Type 709 or Type 732
• 2 small adhesive pads Type 710 or Type 733
SLENDERTONE ABS5 Belt
SLENDERTONE Belt Extension
Material fabrics:
Outer material: 100%Nylon
Binding: 82% Nylon, 18% Elastane
Velcro: 100% Nylon
Foam: 100% Polyurethane
R a t e d O u t p u t s V o l t a g e / C u r r e n t :
P a r a m e t e r 5 0 0 Ω 1 K Ω 1 K 5 Ω
Output RMSV 9.2V 14.8V 17.4V
Output RMSA 18.4mA 14.8mA 11.6mA
Output Frequency 50-99Hz. 50-99Hz. 50-99Hz.
DC Component: Approx. 0 C 0 C 0 C
Positive Pulse Width: 200–350 µs 200–350 µs 200–350 µs
Negative Pulse Width: 200–350 µs 200–350 µs 200–350 µs
Interphase Interval: 100 ± 40 µs 100 ± 40 µs 100 ± 40 µs
T
T
ECHNICAL
ECHNICAL
SPECIFICATIONS
SPECIFICATIONS
To Next Page
Loading...
