5
SETTING UP YOUR BATTERY CHARGER
1. Use either the 2-pin plug (Europe), or the 3-pin plug (UK/ Ireland).
2. Connect the plug to the main body of the charger.
3. Press the plug into the charger until it “clicks” into place.
4. Connect the other end of the charger lead to the controller. Plug the
charger into a socket and switch the socket on. It will take approximately
2-3 hours to fully charge the battery.
5. Your controller is fully charged when all three sections of the battery icon
on the display are full. Disconnect the controller from the charger.
1
EU
2
3
4
English
5
To Next Page
Loading...
