Distributed by: Compex Technologies Inc., 1811 Old Highway 8, New Brighton, MN 55112.
Contents
S h o r ts for Bottom and Thigh Toning System
The Proven Solution to Firm, Tighten and Tone your Bottom and Thighs
Setup
Pad Application
BT Shorts Application
Attach Pads
Remove the covers from the patterned side of the
GelPads and place them, grid side down, onto the
shorts. Start with the back of the shorts, placing grid
side of the GelPads on the small and large positions
indicated, completely covering the metal studs.
When completed, turn the shorts over and place
GelPads on the front pad positions. The GelPads can
be adjusted to match different markings according
to your size (small, medium or large).
1
3
4
2
A
B
C
Insert Batteries
The unit uses three 1.5V (LR03/AAA)
batteries. Insert the batteries as per
the diagram inside the battery com-
partment and replace the cover.
Pad Layout
Front Back
Without taking the liners off of the
GelPads, open the shorts at the waist and
legs and pull the BT shorts on completely.
In order to position the pads, you must first turn your
Slendertone Flex Bottom and Thigh (BT) shorts inside
out and place on a flat surface. Begin with the back of
the shorts facing upwards.
S M L
Putting on the BT
shorts
Adhesive Pads
S l e n d e r tone Flex
Bottom & Thigh To n i n g
( B T) Short s
Instruction Manual
Batteries
Slendertone Flex
Control Unit
P/N 910162 Rev. A
Quick Start Guide
You must read the instruction manual before using the
Slendertone Flex Shorts for Bottom and Thigh Toning System
www.slendertone.com
For customer service call:
1-800-551-2443
Flex BT QSG US 27/06/05 17:19 Page 1
To Next Page
Need help?
General
