How to make Slendertone Personal Care Products stimulation more comfortable?
To improve the comfort of the stimulation, ensure the pads are positioned correctly and pressed firmly against your skin. Reposition the belt as described in the setup section. You can also put a few drops of water on the black surface of the pads, being careful not to get water on the unit. Also, make sure the metal studs are fully covered by the pads.
What to do if Slendertone Personal Care Products power light doesn't come on?
If the power light doesn't come on and there is no signal from the unit, the batteries may not be inserted correctly, or the batteries may be dead or of poor quality. Insert the batteries as described in the set up section. Try inserting new, high quality alkaline batteries.
Why are Slendertone Personal Care Products contractions weak at high intensity?
Weak contractions, even at high intensity, can be due to several reasons. The pads may be worn, or not positioned correctly. Also, low batteries or pads not covering the studs can cause this problem. Reposition the pads so that the metal studs are covered. Insert new batteries.
Why is my skin red after using Slendertone Personal Care Products?
Redness after exercise is often due to increased blood flow under the skin or pressure from the belt, and it should fade. If the redness is excessive, the toning intensity may be too high. Try using a lower toning intensity for a few days. If the problem persists, stop using the unit.
What to do if I feel tingling in legs using Slendertone Personal Care Products?
A tingling sensation in your legs indicates that the pads are over your hip bone. Moving the two smaller pads upwards and inwards on your waist (i.e. towards the centre of your body) should prevent this. Remember to pause or switch off your device before adjusting the belt or pads.
Why is the programme light flashing on Slendertone Personal Care Products?
If the programme light is flashing, this indicates that the batteries are low. Try inserting new batteries.
Why is the power light flashing with no signal on Slendertone Personal Care Products?
If the power light is flashing and there is no signal, the unit may have been paused. Press the on/off button briefly to unpause the unit.
Instructions for correctly inserting batteries into the toning unit.
Guidance on fully connecting the unit to the toning belt using the attachment pin.
How to switch on the unit and begin the toning process.
Instructions on adjusting the intensity for a strong yet comfortable contraction.
Guidance on increasing intensity during the session for better results.
Recommendation to use the toning belt 5 times a week with rest periods.
Advice to use the strongest toning intensity possible for better results.
Answers to common questions regarding usage, reactions, and troubleshooting.
A troubleshooting guide for common issues encountered with the unit.
Important safety and usage guidelines for all users.
Conditions and situations where the product should not be used.
General| Technology | Electrical Muscle Stimulation (EMS) |
|---|---|
| Intensity Levels | 99 |
| Programs | 10 |
| Power Source | Rechargeable Battery |
| Muscle Groups Targeted | Abdominals |
| Battery Type | Lithium-ion |
| Battery Life | Up to 20 hours |
| Charging Time | 3 hours |
| Water Resistance | No |
| Warranty | 2 years |
To Next Page